Log in

View Full Version : Coulson style perch



shanejorgensen
12-08-2016, 01:04 PM
These perches are modeled off of the Coulsons design in their book. I was making myself one and figured that I may as well make a few more to make them available to folks who want them since not everyone has a welder.

Total width: 12 1/2 inches
Total perching height: 11"
Total height: 23"
Ring inside diameter: 3 1/4"

All these measurements are very close. My perches are hand formed. No fancy machines here so there is a little variable but not much. Since they are hand formed they have a very slight tweak in them that isn't noticeable unless you stand above it and look down and look for it. But I want to be 100% fourth coming because I want you to be happy with them.

They are stainless steel and should last you forever.

I did not wrap these so it will be up to you to wrap your perch. Everyone has different ideas of what they like.

In the lower 48 I'm charging $100 per perch shipped to your door. Shipping gets kind of expensive and can vary so I'm just making the perch $100 with free shipping in the 48.

Email me if you have questions:
Shanejorgensen@hotmail.comhttp://uploads.tapatalk-cdn.com/20161208/d6ab00ff18d9a26e62a81b5b12911b67.jpghttp://uploads.tapatalk-cdn.com/20161208/bc2a114c930a2a0245868a7fd5f0ca45.jpg


Sent from my iPhone using Tapatalk

shanejorgensen
12-08-2016, 01:22 PM
My real name: Shane Jorgensen


Shane Jorgensen

shanejorgensen
12-10-2016, 09:27 PM
Sold out


Shane Jorgensen